Tension Clamp Assembly (Drop Fibre Accessories)
Applications
Tension Drop Fiber assemblies are used to firmly hold ADSS cable to a concrete, wood or steel pole and transmit the mechanical tension throughout the cable length. The tension drop Fiber assembly is mounted in a set of two tension drop Fiber fixtures with a pole clamp
Reviews (0)
Related products
Suspension Fitting Assembly (Helix Type-II)
Product Overview
Suspension Fitting Assembly shall be used for holding the aerial Optical Fiber Cable against the dynamic stress of Aeolian vibration at the suspension points. These types of fittings shall be installed at all the intermediate poles between tension poles. This type of fitting also reduces static stresses at the support point.
Pole Clamp/Universal Pole Clamp
Applications
Pole clamp is a key product in the whole Cable laying accessories set as it acts as the sole connector between pole & all the other accessories being installed. Design of pole clamp can vary from pole to pole. Riddhi Infratel has also • developed a Universal Pole Clamp which can be installed on any pole, irrespective of size and shape with the help of SS Strap and Buckle.
Suspension ClampAssembly (Edge Type)
Applications
Suspension Clamp Assembly shall be used for holding the aerial ADSS & OPGW cable at an intermediate point of support such as pole or cross arm when the cable route deviates up to 20°. It is specially designed keeping in mind the issue of installation. It can be mounted by both SS Strap & Buckle or Nuts & bolts.
Suspension Clamp Assembly ((Drop Fibre Accessories)
Applications
Suspension Drop Fiber Assembly shall be used for holding the aerial ADSS & OPGW cable at an intermediate point of support such as pole/ cross arm/ wall with the help of SS Strap or nuts and bolts when the cable route deviates up to 20°. It is specially designed for Cable dia between 5-8mm and 2-4 Fiber cables.
Cable Storage Bracket Assembly (Helix Type-II)
Product Overview
Cable Storage Bracket Assembly shall be used for storing Optical Fiber Cable for future repair & maintenance which has to be carried out at regular intervals & to be installed at terminating points if required. This Bracket is made up of Hot Dip Galvanized steel will serve the purpose on both the pole to pole & pole to wall spans.
Suspension Fitting Assembly (Helix Type-I)
Product Overview
Suspension Fitting Assembly shall be used for holding the aerial Optical Fiber Cable against the dynamic stress of Aeolian vibration at the suspension points. These types of fittings shall be installed at all the intermediate poles between tension poles. This type of fitting also reduces static stresses at the support point.
Dead End & Termination Fittings (Helix Type-II)
Product Overview
Dead End & Termination Fittings are designed for dead-ending aerial ADSS cables on access networks & are installed on the Tension or Terminating poles where splices are located or at the poles where the overhead alignment takes a turn of angle exceeding more than 15°. Span length between Tension poles does not exceed more than 90 meter. These fittings relieve the optical fiber cable of its compressive, bending & clamping stresses.
Reviews
There are no reviews yet.