Click to enlarge
Tension Clamp Assembly (Drop Fibre Accessories)
Back to products
Adjustable Cable Storage Bracket

Suspension Clamp Assembly ((Drop Fibre Accessories)

Applications

Suspension Drop Fiber Assembly shall be used for holding the aerial ADSS & OPGW cable at an intermediate point of support such as pole/ cross arm/ wall with the help of SS Strap or nuts and bolts when the cable route deviates up to 20°. It is specially designed for Cable dia between 5-8mm and 2-4 Fiber cables.

Category:
Reviews (0)

Reviews

There are no reviews yet.

Be the first to review “Suspension Clamp Assembly ((Drop Fibre Accessories)”

Your email address will not be published. Required fields are marked *

Related products

Pole Clamp/Universal Pole Clamp

Applications Pole clamp is a key product in the whole Cable laying accessories set as it acts as the sole connector between pole & all the other accessories being installed. Design of pole clamp can vary from pole to pole. Riddhi Infratel has also • developed a Universal Pole Clamp which can be installed on any pole, irrespective of size and shape with the help of SS Strap and Buckle.

Dead End & Termination Fittings (Helix Type-I)

Product Overview Dead End & Termination Fittings are designed for dead-ending aerial ADSS cables on access networks & are installed on the Tension or Terminating poles where splices are located or at the poles where the overhead alignment takes a turn of angle exceeding more than 15°. Span length between Tension poles does not exceed more than 75m. These fittings relieve the optical fiber cable of its compressive, bending & clamping stresses.

Tension Clamp Assembly (Drop Fibre Accessories)

Applications Tension Drop Fiber assemblies are used to firmly hold ADSS cable to a concrete, wood or steel pole and transmit the mechanical tension throughout the cable length. The tension drop Fiber assembly is mounted in a set of two tension drop Fiber fixtures with a pole clamp

Dead End & Termination Fittings (Helix Type-II)

Product Overview Dead End & Termination Fittings are designed for dead-ending aerial ADSS cables on access networks & are installed on the Tension or Terminating poles where splices are located or at the poles where the overhead alignment takes a turn of angle exceeding more than 15°. Span length between Tension poles does not exceed more than 90 meter. These fittings relieve the optical fiber cable of its compressive, bending & clamping stresses.

Demountable Pulleys (Helix Type-I)

Product Overview Demountable Pulleys are used during the installation of Aerial Optical Fiber Cables. These are made from Mild Steel & the contour of the wheel is coated with rubber or any other suitable material for free movement of the Aerial Optical Fiber Cable.

Suspension Fitting Assembly (Helix Type-II)

Product Overview Suspension Fitting Assembly shall be used for holding the aerial Optical Fiber Cable against the dynamic stress of Aeolian vibration at the suspension points. These types of fittings shall be installed at all the intermediate poles between tension poles. This type of fitting also reduces static stresses at the support point.

Suspension ClampAssembly (Edge Type)

Applications Suspension Clamp Assembly shall be used for holding the aerial ADSS & OPGW cable at an intermediate point of support such as pole or cross arm when the cable route deviates up to 20°. It is specially designed keeping in mind the issue of installation. It can be mounted by both SS Strap & Buckle or Nuts & bolts.

Suspension Fitting Assembly (Helix Type-I)

Product Overview Suspension Fitting Assembly shall be used for holding the aerial Optical Fiber Cable against the dynamic stress of Aeolian vibration at the suspension points. These types of fittings shall be installed at all the intermediate poles between tension poles. This type of fitting also reduces static stresses at the support point.