Pole Clamp/Universal Pole Clamp

Applications Adjustable Cable Storage Bracket Assembly is used to store the excess ADSS & OPGW cable which is being maintained in the middle of the line on the poles or cross arms & to use at the time of joints. SS Strip: SS Strap with casing is supplied in 50m roll with indication of remaining length. SS Strap with Buckle shall be used for mounting the bracket on the pole as per load requirement. Minimum two loops of 0.75 meter each with one Buckle shall be considered for attaching the brackets to the poles.

Applications Anchoring assemblies shall be used to firmly hold ADSS cable to a concrete, wood or steel pole and transmit the mechanical tension at the end of a run, tensioning points and a major change in direction of over 20 degrees.  

Applications Tension Drop Fiber assemblies are used to firmly hold ADSS cable to a concrete, wood or steel pole and transmit the mechanical tension throughout the cable length. The tension drop Fiber assembly is mounted in a set of two tension drop Fiber fixtures with a pole clamp

Product Overview Dead End & Termination Fittings are designed for dead-ending aerial ADSS cables on access networks & are installed on the Tension or Terminating poles where splices are located or at the poles where the overhead alignment takes a turn of angle exceeding more than 15°. Span length between Tension poles does not exceed more than 90 meter. These fittings relieve the optical fiber cable of its compressive, bending & clamping stresses.