Click to enlarge
Strap Binding Cutting Tool
Strap Binding Cutting Tool
Back to products
6 Port Nano Din rail Patch panel
6 Port Nano Din rail Patch panel

SS Strap & Buckle

Applications

SS Strap & Buckle is a specially designed & developed product to provide ease in installation of accessories. This tool helps in holding & binding the accessories which are being mounted on the pole. This tool is designed to keep ease in use & provide strength to the network.

Category:
Reviews (0)

Reviews

There are no reviews yet.

Be the first to review “SS Strap & Buckle”

Your email address will not be published. Required fields are marked *

Related products

Dead End & Termination Fittings (Helix Type-I)

Product Overview Dead End & Termination Fittings are designed for dead-ending aerial ADSS cables on access networks & are installed on the Tension or Terminating poles where splices are located or at the poles where the overhead alignment takes a turn of angle exceeding more than 15°. Span length between Tension poles does not exceed more than 75m. These fittings relieve the optical fiber cable of its compressive, bending & clamping stresses.

Dead End & Termination Fittings (Helix Type-II)

Product Overview Dead End & Termination Fittings are designed for dead-ending aerial ADSS cables on access networks & are installed on the Tension or Terminating poles where splices are located or at the poles where the overhead alignment takes a turn of angle exceeding more than 15°. Span length between Tension poles does not exceed more than 90 meter. These fittings relieve the optical fiber cable of its compressive, bending & clamping stresses.

Pole Clamp/Universal Pole Clamp

Applications Pole clamp is a key product in the whole Cable laying accessories set as it acts as the sole connector between pole & all the other accessories being installed. Design of pole clamp can vary from pole to pole. Riddhi Infratel has also • developed a Universal Pole Clamp which can be installed on any pole, irrespective of size and shape with the help of SS Strap and Buckle.

Strap Binding Cutting Tool

Applications Strap Binding Cutting Tool is a specially designed & developed to provide ease in installation of accessories. This tool helps in cutting & binding the SS strap along the pole for gripping the accessories being mounted on pole. This tool is designed to keep ease in use & improve efficiency in installation of accessories.

Tension Clamp Assembly (Drop Fibre Accessories)

Applications Tension Drop Fiber assemblies are used to firmly hold ADSS cable to a concrete, wood or steel pole and transmit the mechanical tension throughout the cable length. The tension drop Fiber assembly is mounted in a set of two tension drop Fiber fixtures with a pole clamp

Suspension Fitting Assembly (Helix Type-I)

Product Overview Suspension Fitting Assembly shall be used for holding the aerial Optical Fiber Cable against the dynamic stress of Aeolian vibration at the suspension points. These types of fittings shall be installed at all the intermediate poles between tension poles. This type of fitting also reduces static stresses at the support point.

Suspension Fitting Assembly (Helix Type-II)

Product Overview Suspension Fitting Assembly shall be used for holding the aerial Optical Fiber Cable against the dynamic stress of Aeolian vibration at the suspension points. These types of fittings shall be installed at all the intermediate poles between tension poles. This type of fitting also reduces static stresses at the support point.

Down Lead Clamp (Edge Type)

Applications Down Lead Clamp is used to properly fix the aerial ADSS cable on the pole or cross arms to avoid the movement of the cable under wind condition. The Down Lead Clamp has the provision to fix it on the pole or cross arms by Stainless Steel Straps & Buckles.