Click to enlarge
Adjustable Cable Storage Bracket
Adjustable Cable Storage Bracket
Back to products
Strap Binding Cutting Tool
Strap Binding Cutting Tool

Pole Clamp/Universal Pole Clamp

Applications

Pole clamp is a key product in the whole Cable laying accessories set as it acts as the sole connector between pole & all the other accessories being installed. Design of pole clamp can vary from pole to pole. Riddhi Infratel has also • developed a Universal Pole Clamp which can be installed on any pole, irrespective of size and shape with the help of SS Strap and Buckle.

Category:
Reviews (0)

Reviews

There are no reviews yet.

Be the first to review “Pole Clamp/Universal Pole Clamp”

Your email address will not be published. Required fields are marked *

Related products

Strap Binding Cutting Tool

Applications Strap Binding Cutting Tool is a specially designed & developed to provide ease in installation of accessories. This tool helps in cutting & binding the SS strap along the pole for gripping the accessories being mounted on pole. This tool is designed to keep ease in use & improve efficiency in installation of accessories.

Down Lead Clamp (Edge Type)

Applications Down Lead Clamp is used to properly fix the aerial ADSS cable on the pole or cross arms to avoid the movement of the cable under wind condition. The Down Lead Clamp has the provision to fix it on the pole or cross arms by Stainless Steel Straps & Buckles.

Dead End & Termination Fittings (Helix Type-II)

Product Overview Dead End & Termination Fittings are designed for dead-ending aerial ADSS cables on access networks & are installed on the Tension or Terminating poles where splices are located or at the poles where the overhead alignment takes a turn of angle exceeding more than 15°. Span length between Tension poles does not exceed more than 90 meter. These fittings relieve the optical fiber cable of its compressive, bending & clamping stresses.

Cable Storage Bracket Assembly (Helix Type-II)

Product Overview Cable Storage Bracket Assembly shall be used for storing Optical Fiber Cable for future repair & maintenance which has to be carried out at regular intervals & to be installed at terminating points if required. This Bracket is made up of Hot Dip Galvanized steel will serve the purpose on both the pole to pole & pole to wall spans.

SS Strap & Buckle

Applications SS Strap & Buckle is a specially designed & developed product to provide ease in installation of accessories. This tool helps in holding & binding the accessories which are being mounted on the pole. This tool is designed to keep ease in use & provide strength to the network.

Demountable Pulleys (Helix Type-I)

Product Overview Demountable Pulleys are used during the installation of Aerial Optical Fiber Cables. These are made from Mild Steel & the contour of the wheel is coated with rubber or any other suitable material for free movement of the Aerial Optical Fiber Cable.

Anchoring / Tensioning Clamp assembly (Edge Type)

Applications Anchoring assemblies shall be used to firmly hold ADSS cable to a concrete, wood or steel pole and transmit the mechanical tension at the end of a run, tensioning points and a major change in direction of over 20 degrees.  

Suspension Fitting Assembly (Helix Type-I)

Product Overview Suspension Fitting Assembly shall be used for holding the aerial Optical Fiber Cable against the dynamic stress of Aeolian vibration at the suspension points. These types of fittings shall be installed at all the intermediate poles between tension poles. This type of fitting also reduces static stresses at the support point.