Click to enlarge
Pole Clamp/Universal Pole Clamp
Pole Clamp/Universal Pole Clamp
Back to products
SS Strap & Buckle
SS Strap & Buckle

Strap Binding Cutting Tool

Applications

Strap Binding Cutting Tool is a specially designed & developed to provide ease in installation of accessories. This tool helps in cutting & binding the SS strap along the pole for gripping the accessories being mounted on pole. This tool is designed to keep ease in use & improve efficiency in installation of accessories.

Category:
Reviews (0)

Reviews

There are no reviews yet.

Be the first to review “Strap Binding Cutting Tool”

Your email address will not be published. Required fields are marked *

Related products

SS Strap & Buckle

Applications SS Strap & Buckle is a specially designed & developed product to provide ease in installation of accessories. This tool helps in holding & binding the accessories which are being mounted on the pole. This tool is designed to keep ease in use & provide strength to the network.

Suspension ClampAssembly (Edge Type)

Applications Suspension Clamp Assembly shall be used for holding the aerial ADSS & OPGW cable at an intermediate point of support such as pole or cross arm when the cable route deviates up to 20°. It is specially designed keeping in mind the issue of installation. It can be mounted by both SS Strap & Buckle or Nuts & bolts.

Adjustable Cable Storage Bracket

Applications Adjustable Cable Storage Bracket Assembly is used to store the excess ADSS & OPGW cable which is being maintained in the middle of the line on the poles or cross arms & to use at the time of joints. SS Strip: SS Strap with casing is supplied in 50m roll with indication of remaining length. SS Strap with Buckle shall be used for mounting the bracket on the pole as per load requirement. Minimum two loops of 0.75 meter each with one Buckle shall be considered for attaching the brackets to the poles.

Suspension Fitting Assembly (Helix Type-I)

Product Overview Suspension Fitting Assembly shall be used for holding the aerial Optical Fiber Cable against the dynamic stress of Aeolian vibration at the suspension points. These types of fittings shall be installed at all the intermediate poles between tension poles. This type of fitting also reduces static stresses at the support point.

Tension Clamp Assembly (Drop Fibre Accessories)

Applications Tension Drop Fiber assemblies are used to firmly hold ADSS cable to a concrete, wood or steel pole and transmit the mechanical tension throughout the cable length. The tension drop Fiber assembly is mounted in a set of two tension drop Fiber fixtures with a pole clamp

Dead End & Termination Fittings (Helix Type-II)

Product Overview Dead End & Termination Fittings are designed for dead-ending aerial ADSS cables on access networks & are installed on the Tension or Terminating poles where splices are located or at the poles where the overhead alignment takes a turn of angle exceeding more than 15°. Span length between Tension poles does not exceed more than 90 meter. These fittings relieve the optical fiber cable of its compressive, bending & clamping stresses.

Pole Clamp/Universal Pole Clamp

Applications Pole clamp is a key product in the whole Cable laying accessories set as it acts as the sole connector between pole & all the other accessories being installed. Design of pole clamp can vary from pole to pole. Riddhi Infratel has also • developed a Universal Pole Clamp which can be installed on any pole, irrespective of size and shape with the help of SS Strap and Buckle.

Anchoring / Tensioning Clamp assembly (Edge Type)

Applications Anchoring assemblies shall be used to firmly hold ADSS cable to a concrete, wood or steel pole and transmit the mechanical tension at the end of a run, tensioning points and a major change in direction of over 20 degrees.