Applications
Suspension Fitting Assembly will be used for holding aerial ADSS cable at all intermediate poles between tension poles. Suitable for cables with 8-18 mm diameter where tensile strength is less than 10 kN.
Suspension Fitting Assembly (Helix Type-I)
Product Overview
Suspension Fitting Assembly shall be used for holding the aerial Optical Fiber Cable against the dynamic stress of Aeolian vibration at the suspension points. These types of fittings shall be installed at all the intermediate poles between tension poles. This type of fitting also reduces static stresses at the support point.
Description
Reviews (0)
Related products
Cable Storage Bracket Assembly (Helix Type-II)
Product Overview
Cable Storage Bracket Assembly shall be used for storing Optical Fiber Cable for future repair & maintenance which has to be carried out at regular intervals & to be installed at terminating points if required. This Bracket is made up of Hot Dip Galvanized steel will serve the purpose on both the pole to pole & pole to wall spans.
Strap Binding Cutting Tool
Applications
Strap Binding Cutting Tool is a specially designed & developed to provide ease in installation of accessories. This tool helps in cutting & binding the SS strap along the pole for gripping the accessories being mounted on pole. This tool is designed to keep ease in use & improve efficiency in installation of accessories.
Pole Clamp/Universal Pole Clamp
Applications
Pole clamp is a key product in the whole Cable laying accessories set as it acts as the sole connector between pole & all the other accessories being installed. Design of pole clamp can vary from pole to pole. Riddhi Infratel has also • developed a Universal Pole Clamp which can be installed on any pole, irrespective of size and shape with the help of SS Strap and Buckle.
Dead End & Termination Fittings (Helix Type-I)
Product Overview
Dead End & Termination Fittings are designed for dead-ending aerial ADSS cables on access networks & are installed on the Tension or Terminating poles where splices are located or at the poles where the overhead alignment takes a turn of angle exceeding more than 15°. Span length between Tension poles does not exceed more than 75m. These fittings relieve the optical fiber cable of its compressive, bending & clamping stresses.
Suspension ClampAssembly (Edge Type)
Applications
Suspension Clamp Assembly shall be used for holding the aerial ADSS & OPGW cable at an intermediate point of support such as pole or cross arm when the cable route deviates up to 20°. It is specially designed keeping in mind the issue of installation. It can be mounted by both SS Strap & Buckle or Nuts & bolts.
Reviews
There are no reviews yet.